The Function Discovery Provider Host service fdPHost is enabled and running although to my understanding this is not necessary for service discovery. Network discovery and file and printer sharing are both turned on for the active network profile Private in advanced sharing settings. The IPv6 address ffc is a link-local multicast address and is not routed to the other network, but the request sent to But these devices are not displayed in Windows Explorer.
There is a section about configuration settings that can be changed with registry keys. Most of the mentioned registry-paths exist, but none of the mentioned keys are set. The keys DownloadScope and ReceiveScope both default to 1 , which allows discovery of hosts in private subnets. Sorry this didn't help. Thanks for your feedback. I using Cisco routers with IOS This thread is locked. You can follow the question or vote as helpful, but you cannot reply to this thread.
I have the same question 2. Report abuse. Details required :. Reply can we apply these setting on both laptop 0. Reply it should be no problem. Reply Thanks so much, it was very useful. Reply Thanks so much. I probably never would had found this on my own.
It solved my networking issue :D 0. Reply Thanks mate. Reply Hi, I have a small network in my office Reply Feel free to try and implement what I describe in my post. Reply I have successfully gotten this method to work. Reply Not sure why it is slow. Reply then it sounds like your firewall is misconfigured. Reply Hello, Pl help how to share file over two different service provider. Reply Thanks for writing this — it solved my file sharing problem.
A couple of suggestions: At: and choose the profile that your network is in Private, Public, Domain. Reply Thanks for your input. I made a few small changes, it must be a bit clearer now. Reply Thanks for sharing. Works for Windows 8. Reply Thank you! Very clean write up. Solved my issue quickly. Reply I have an apartment setup where the different rooms are all wired to a central hub in the closet. Reply Ryan, typically switches do not offer a user interface to configure them, as is the case with routers.
Reply Hi Sigmoid Thanks for this info — very useful. Can you shed any light on this? Reply The inbound port need to allow connections from remote hosts so they can see each other.
Leave a Comment Cancel Reply. Your comment.
0コメント